Reference; Arm Installation Procedure - Eizo DuraVision FDF2382WT-A User Manual

7 | Reference

7 Reference

7.1 Arm Installation Procedure

An optional arm (or an optional stand) can be attached by removing the stand section.
Please refer to our website for supported optional arms (or optional stands).
(www.eizoglobal.com)
When attaching an arm or stand, the installable orientations and movement range (tilt angle)
are as follows:
• Orientation
• Movement range (tilt angle)
Attention
• When attaching an arm or stand, follow the instructions of the respective User's Manual.
• When using another manufacturer's arm or stand, confirm the following in advance with the
manufacturer and select one conforming to the VESA standard.
– Clearance between screw holes: 100 mm x 100 mm
– Plate thickness: 2.6 mm
– Strong enough to support weight of the monitor unit (excluding the stand) and attachments
such as cables
• When using another manufacturer's arm or stand, use the following screws to secure it.
– Screws fixing the stand to the monitor
• Connect the cables after attaching an arm or stand.
• The monitor, arm, and stand are heavy. Dropping them may result in injury or equipment
damage.
• Check periodically that the screws are tight enough. If the screws are not tight enough, the
monitor may come unattached. This may be the cause of injury or damage.
1. Lay the LCD monitor on a soft cloth spread over a stable and flat surface with the LCD
panel surface facing down.
2. Remove the stand.
Using a screwdriver, remove the screws securing the unit and the stand.
34
Up: 0˚ Up: 90˚