Table of Contents
Advertisement
Operation
3. Hold the wall bracket on the installation surface and mark
the three locations for fastening.
4. Drill two holes into the wall using a drill
wall plugs
5. Screw the wall bracket to the fastening points with the
screws
18
surface (see Fig. C). Use a cross-head screwdriver
this purpose. Do not apply excessive force in the process.
6. Slide the solar panel
onto the wall bracket until you hear it click into place
(see Fig. C).
7. Completely unfold the charging cable and insert the
plug
into the charging slot
14
Operation
Configuring the sensor area
1. If necessary, turn the motion sensor housing
the SENS controller
2. Select the required sensor area:
− Turning the SENS controller clockwise increases the
sensor area range and the motion sensor will already
react from a distance of approx. 12 m.
− Turning the SENS controller anticlockwise decreases
the sensor area range. With the lowest setting, the
motion sensor only reacts starting at a distance of
approx. 1 m.
To further adjust the sensor area, turn the motion sensor
housing
. The motion sensor housing can be turned by 90°
10
(see Fig. D). The sensor angle of approx. 110° (+/-10°) does not
change in the process.
20
.
17
as based on the properties of the installation
and back cover from above
15
.
3
and insert the
19
on the spotlight
9
10
for
20
.
7
to reach
Advertisement
Table of Contents
