Table of Contents
Advertisement
To avoid triggering the product unintentionally,
the product must be installed firmly. If the product
moves, this has the same effect as moving heat
sources in the sensor area.
Mounting the spot light
1. Choose a suitable surface for installation (see chapter
section "Selecting the installation location").
2. Remove the rear panel
unscrewing the fixing screw
3. Hold the rear panel (for wall installation) or wall bracket
(for corner installation) to the installation surface and
13
mark the installation locations.
4. Drill two holes into the wall using a drill
wall plugs
5. Screw the rear panel or the wall bracket to the fastening
points with screws
the installation surface (see Fig. B). Use a cross-head
screwdriver
force in the process.
6. Attach the spotlight to the rear panel or wall bracket.
7. Use the fixing screw to fasten the spotlight and the rear
panel or wall bracket.
8. Tighten the fixing screw.
Mounting the solar panel
1. Choose a suitable surface for installation (see chapter
section "Selecting the installation location").
2. Remove the wall bracket
Press the plastic tab up slightly to do this.
8
.
17
as based on the properties of
18
for this purpose. Do not apply excessive
20
from the spotlight
.
6
from the back cover.
16
Assembly
by
7
and insert the
19
19
Advertisement
Table of Contents
