Fisher & Paykel OR90 Using Manual page 15

. The rear cooking display will show
.
If no pan is detected on one cooking zone:
The front cooking zone display will still show the selected temperature and the rear cooking zone display will still show
.
If after 10 minutes no pan is detected:
• the bridging function will switch off
• the cooking zone without a detectable pan will continue to show
• the remaining cooking zone will continue cooking at the selected heat setting.
Using Auto RapidHeat in Bridged Mode
1. Bridge the cooking zones.
2. Turn the control dial for the front cooking zone back past OFF to A.
3. Hold the dial at A until
starts alternating in the display.
4. Turn the control dial to your selected heat setting. the Heat setting and
will alternate in the display.
5. The bridged zone is now set for Auto RapidHeat.
To Cancel Bridging
Turn both control dials back to OFF.
https://producthelp.fisherpaykel.com/au/Cook/Freestanding_Cookers/Induction/OR90SCI4B1/User_Guide_OR90SCI4B1/05_...
Updated: Thu, 04 Nov 2021 16:39:30 GMT
Powered by
15