Table of Contents
Advertisement
GS I n
[Function]
[Code]
[Range]
[Outline]
[Caution]
Sending the printer ID
<1D>H<49>H<n>
1
n
3 49
n
Sends the specified printer ID.
n
Type of printer ID
1,49
Model ID
2,50
Type ID
3,51
ROM version ID
Type ID If n=2, 50 is specified:
Bit
0
Equipped for 2 byte code support
1
Equipped with autocutter
Thermosensitive paper Label
2
Label paper(when "Label" is selected)
3
4
5
6
7
• Under DTR/DSR control, the printer sends the printer ID after verifying
that the host is ready to receive. If the host is not ready to receive, the
printer waits for the host to become ready to receive.
• Under XON/XOFF control, the printer sends the printer ID without
checking whether the host is ready to receive or busy.
• Because this command is executed when data is mapped in the receive
buffer, there may be a delay between command receiving and printer
ID sending depending on the condition of the receive buffer.
• If ASB (Automatic Status Back) is enabled by GS a, the host must
discriminate between the printer ID due to this command and the
status due to ASB.
51
Specification
CBM1000
Refer to table "Type ID" below
As per ROM version
Meaning
Undefined
Unused
Undefined
Undefined
Unused
— 65 —
Value (Hex.)
30
Hex.
Decimal
01
1
02
2
—
—
—
—
—
—
00
0
—
—
—
—
00
0
Advertisement
Table of Contents
