Table of Contents
Advertisement
ESC n n
[Function]
[Code]
[Range]
[Outline]
[Caution]
[Default]
[Sample Program]
Setting a remaining amount of printout
<1B>H<6E>H<n>
0
n
255 ("n" in the 2nd byte denotes this command.)
This command sets the remaining amount of printing after
detecting paper near end 1. n is set in cm.
• If the paper near end (PNE) sensor is disabled, this command
has no function.
• The set value and the remaining amount of printing are not
cleared by the initialize command (ESC @).
• If a value lower than the preset value is set during PNE
detection, the printer may stop printing.
• The set value remains valid until the printer is restarted or the
a new value is set.
n=150 (150 cm)
LPRINT CHR$ (&H1B); "n"; CHR$ (100);
— 50 —
When setting the
remaining amount of
printing to 100 cm
Advertisement
Table of Contents
