Table of Contents
Advertisement
10
Starting (manual)
1. Check the pump type (type plate) and the characteristics of the pump unit, such as: rpm, operating pressure,
power consumption, operating temperature, etc.
2.
Check whether the pump unit is placed in accordance with the instructions. Pay particular attention to the area
around the pump unit. Make sure the pump unit can draw adequate fresh air.
3. Check whether the prescribed safety provisions are in place.
4. Connect the hoses
5. Perform daily maintenance.
6.
Make sure there is sufficient fuel in the fuel tank.
7.
Bleed the fuel system, if necessary.
8.
Perform the general steps for starting the pump
9.
Switch on earth switch (1).
10. Turn the switch Betonite – Water (2). If needs to pump water then must turn switch (2) to "water" position,
if need to pump betonite then turn switch to "betonite" side.
21
Advertisement
Table of Contents
