IMC Networks MediaConverter/1 Operation Manual page 14
Imc networks mediaconverter/1 media converters: install guide
Hide thumbs
Also See for MediaConverter/1:
- Specifications (2 pages) ,
- Declaration of conformity (1 page) ,
- Installation manual (8 pages)
Table of Contents
Advertisement
The diagram below shows a typical application, followed by a table with three
possible configurations.
End to End Connection
Half-Duplex
Full-Duplex
Full-Duplex
Configure Auto-Negotiation on McLIMs with a 3-pin jumper block located on the
module. Please see the diagrams on page 3 and chart on page 4 of this manual to
verify jumper position and default setting.
Auto-Negotiation on McLIM TP-TX/FX
Auto-Negotiation is a standard feature on McLIM TP-TX/FX. The fiber port always
operates at 100 Mbps Full-Duplex; the copper port auto-senses the connected
device's speed and duplex mode: 10 Mbps or 100 Mbps and Half-Duplex or Full-
Duplex (including Flow Control).
McLIM TP-TX/FX is a Plug-And-Play device with Auto-Negotiation always enabled.
The following chart states the availability of Auto-Negotiation on media conversion
modules.
McPIM TP/FO Auto
McLIM TX/FX and TX/SX Auto
McLIM TP-TX/FX
Switch
Manually configure HDX
Manually configure FDX
Auto-Negotiation On
Note
Auto-Negotiation Product Comparison
Negotiation
Negotiation
TX/FX Auto
Auto-Negotiation Off
Auto-Negotiation Off
Auto-Negotiation On
Not Available/Applicable
DIP Switch Selectable
Negotiation Always Enabled
14
TX/FX
Hide quick links:
Advertisement
Table of Contents
