Yuria-Pharm ULAIZER HOME CN-02 MY User Manual page 13

EN 22
1. Remove your ULAIZER HOME CN-02MY unit from the packaging, place it on a flat
and stable surface. Be sure that you can easily reach the controls when you are
seated and ensure that the ventilation slits are free.
2. Make sure the switch in the "OFF" position.
3. Gently twist the top part of the nebulizer bottle counter-clockwise to disassem-
ble the nebulizer bottle (Figure 1).
4. Fill the nebulizer bottle with the medication prescribed by your physician
(Figure 2).
Note: Fill with medication directly into the nebulizer bottle, do not fulfill. The
recommended fill level is 5ml.
Use medication only on the advice of a physician, and check the appropriate inha-
lation duration and quantity for your needs.
5. Gently twist the top part clockwise to re-assemble the nebulizer bottle. Be sure
the two sections fit well (Figure 3).
6. Connect the air tube with nebulizer bottle (Figure 4).
7. Connect the other end of the air tube to the tube connector on the nebulizer
unit by lightly turning it (Figure 5).
8. Firmly connect the mask, mouth piece, nose piece with nebulizer bottle (Figure 6).
9. Hold the nebulizer bottle as shown on the picture and follow the instructions of
your doctor or respiratory therapist. Exhale as normal through the mouth piece,
mask or nose (Figure 7, 7a).
10. Plug the power cord into an appropriate electrical outlet. Make sure at this
stage, the power switch is at "OFF" position.
11. Press power switch to begin your prescribed treatment.
12. Switch off the nebulizer device after treatment. Unplug the power cable from
the electrical outlet.
Fig. 1 Fig. 2
4. USAGE
Fig. 3 Fig. 4
USER'S MANUAL
Fig. 5 Fig. 6
Before you clean the unit, always switch it off, unplug it and let it cool off.
The nebulizer bottle and the used accessories such as mouthpiece, mask, etc. must
be washed with hot water after each use.
Carefully dry all components using a soft cloth. Once all components are fully dry,
reassemble the nebulizer bottle and place the components in a dry, sealed contain-
er or carry out disinfection.
When cleaning, ensure that all residues are removed. Never use any substances
that may be poisonous when in contact with the skin or mucous membranes, or
when swallowed or inhaled.
Clean the device using a damp cloth, to which you can apply a little detergent if
necessary.
Do not use abrasive detergents and never immerse the unit in water.
1. Ensure that no water penetrates inside the unit!
2. Do not put the device or accessories in a dishwasher.
3. Do not touch the unit with wet hands while it is plugged in; do not allow any
water to be sprayed onto the unit. The unit must be operated only when it is
completely dry.
4. Do not spray any liquids into the ventilation slots. Any liquid that penetrates
into the unit can damage the electrical parts or other components of the nebu-
lizer and impair the function of the device.
23
Fig. 7 Fig. 7а
5. CLEANING
Important
EN