Custom Panel Dimensions - Fisher & Paykel DOUBLE DISHDRAWER DD60DTX6I1 Installation Manual

Material specifications
Maximum weight of drawer panels must not exceed 9kg (including handle)
z
The panel should be adequately sealed to withstand moisture (50°C @
z
80% RH). The back and sides of the panel should be completely sealed
with a waterproof vapour barrier, such as polyurethane, to prevent damage.
The back of the panel should be completely flush so that the seal between
z
the panel and the rubber trim is maintained.
Installation outside these specifications may result in condensation on
z
cabinetry surfaces.
Toe kick
A minimum distance of 12mm between the floor and the base of the toe kick
z
must be maintained at all times.
Depending on the desired toe kick recess depth, the custom toe kick panel
z
will need to be aligned to different positions on the toe kick template to
clear the underside of the tub.
Toe kick panel height can be determined by using the below:
z
cavity height upper panel extension
40mm recess
installations: -
l j
cavity height upper panel extension
40 – 100mm recess
-
installations:
l j
Recess of 40mm*
Align to pre-finished panel as shown
Custom panel
40mm
Recess of 40 – 100mm*
Align to pre-finished panel as shown
Custom panel
40 – 100mm
*based on a door panel depth of 18mm

CUSTOM PANEL DIMENSIONS

floor clearance toe kick height
- - =
783mm i
floor clearance toe kick height
- -
=
801mm i
e
c
j
a
f
B
k
d
ISO
CUSTOM PANEL CONSIDERATIONS
A Minimum upper door panel height*
B Minimum lower door panel height*
C Minimum door panel width
D Toe kick panel height*
E Door panel depth
F Minimum toe kick panel depth**
G Minimum clearance between door panels
H Minimum clearance between top of door panel and countertop
I Minimum clearance between toe kick panel and floor
J Maximum extension of upper panel
K Maximum extension of lower panel
L Minimum inside cavity height
M Minimum height from floor to top of bottom drawer panel***
Maximum weight of each drawer panel (including handle)
*the top door panel may be extended up, or the bottom panel down from the fixed gap. Toe kick panel should be adjusted accordingly.
**if using supplied toe kick mounting screws. Panel can be fixed via screwing or gluing to the supplied mounting bracket.
***depending on adjustment of levelling feet
e
h
a
g
B
m
I f
PROFILE
l
MM
442
311
596
45 – 123
16 – 20
9
8
2
12
-
50
864
414
9kg
7