Fisher & Paykel DOUBLE DISHDRAWER DD60DTX6I1 Installation Manual page 14

SECURE TO CABINETRY VIA DRAWER REMOVAL (METHOD B)
5
6
14
Before refitting the drawer, ensure the
hoses are not twisted.
Refit the drawer to the runners and clip
into place via both locking tabs.
INSTALL PRE-FINISHED TOE KICK
Select your preferred pre-finished toe kick based on the depth of your desired toe kick recess.
Toe kick depth of 40 – 56mm
Flush pre-finished toe kick panel
1
2
3
4
min 12mm
Toe kick depth of 56 – 120mm
Recessed pre-finished toe kick panel
Measure toe kick height against
the base of the locking tab. Mark
cutting location on panel.
Carefully score toe kick at
marked height.
Snap off excess toe kick material and
both end tabs.
Smooth the edges.
Slide toe kick onto the mounting rails
and secure. Ensure a 12mm clearance
is maintained between the floor and
the toe kick, the end tabs can be used
to measure this if desired.
Do not over tighten the screws.