Memory Clearing - Icom IC-R20 Instruction Manual

■ Memory clearing

Contents of programmed memories can be cleared (blanked),
if desired.
qPush [MR S.MW] for 1 sec. to select the select memory
write condition.
• 1 short and 1 long beeps sound.
• "µ µ
" indicator blinks.
• Do not hold [MR S.MW] for more than 2 sec. otherwise the
memory contents will be copied to VFO.
wRotate [R-DIAL] to select the desired memory channel to
be cleared.
eWhile pushing [8 SET], rotate [R-DIAL] to select "CLEAR."
• "CLEAR" item can also be selected by pushing [8 SET] several
times.
[R-DIAL]
MR
S.MW
SET
8
FM
144.010
µ
. 028
-BANK-:----
-BNAME:
-MNAME:
-SKIP-:OFF
>CLEAR
SET
After 8 is pushed
several times.
-BANK-:----
-BNAME:
-MNAME:
-SKIP-:OFF
>CLEAR
MEMORY CHANNELS
r Push [MR S.MW] for 1 sec. to clear the contents.
• 3 beeps sound.
• The cleared channel changes to blank channel
• Return to the select memory write condition.— "µ µ " indicator
blinks. Push [DUALWATCH] to exit the select memory write con-
dition, then push [VFO MHz] to return to VFO mode.
Push
S.MW
FM
144.010
µ 028
.
-BANK-:----
-BNAME:
-MNAME:
-SKIP-:OFF
>CLEAR
NOTE: Be careful!— the contents of cleared memories
CANNOT be recalled even in bank channel operation.
MR
for 1 sec.
FM
144.010
µ 028
.
-BANK-:----
-BNAME:
-MNAME:
-SKIP-:OFF
>CLEAR
6
6
32