Icom IC-756PROII Instruction Manual page 74

9
SET MODE
I Miscellaneous (others) set mode
This item sets the auto tuning step function. When ro-
tating the tuning dial rapidly, the tuning step automat-
ically changes several times as selected.
There are 2 type of auto tuning steps: HIGH (Fastest)
and LOW (Faster).
This item sets the rate at which frequencies are
scanned when the microphone [UP]/[DN] switches
are pushed and held. High or low can be selected.
This item selects the RIT/∂TX frequency clearing in-
struction with the [CLEAR] switch.
This item selects the displayed frequency shift func-
tion from ON and OFF.
When this function is activated, the receiving signal
can be kept to receive even when the operating mode
is changed between SSB and CW.
The frequency shifting value may differ according
to the CW pitch setting.
Selects the carrier point of CW mode from LSB and
USB.
72
(continued)
Auto tuning step is turned ON.
Fastest tuning step during rapid rotation
(default)
Auto tuning step is turned ON.
Faster tuning step during rapid rotation
Auto tuning step is turned OFF
High speed (default,
50 tuning steps/sec.)
Clears the RIT/∂TX fre-
quency when [CLEAR] is
pushed momentarily.
The displayed frequency
shifts when the operating
mode is changed between
SSB and CW.
The carrier point is set to
LSB side.
(default)
.
Low speed
(25 tuning steps/sec.)
Clears the RIT/∂TX fre-
quency when [CLEAR] is
pushed for 1 sec.
(default)
The displayed frequency
does not shift.
(default)
The carrier point is set to
USB side.