Ir Hotsync Operations - IBM WorkPad Workpad Handbook

5. Click Change.
6. Click the direction in which you want to write data, or click Do
Nothing to skip data transfer for an application.
Note:
Changing the HotSync setting from the default affects
only the next HotSync operation. Thereafter, the HotSync
Actions revert to their default settings. To use a new
setting on an ongoing basis, select the Set As Default box.
Thereafter, whatever you selected as the default setting is
used when you click the Default button in the Custom
dialog.
7. Click OK.
8. Repeat steps 4 through 7 to change conduit settings for other
applications.
9. Click Done to activate your settings.

IR HotSync operations

Your PC companion is equipped with an infrared (IR) port that
supports the IrCOMM implementation of the standards for infrared
communication established by the Infrared Data Association (IrDA).
This means that not only can you beam data to another Palm OS
handheld that's equipped with an IR port, but you can also beam data
to a mobile phone and any other device that supports the IrCOMM
implementation of the IrDA standards.
Most importantly, you can use the IR port to perform HotSync
operations; you don't need your cradle. This is especially useful if you
travel with an infrared-enabled laptop. You simply enable infrared
communication on your laptop and PC companion and follow the
steps in "Performing an IR HotSync operation" later in this section.
Chapter 7 Page 169