Table of Contents
Advertisement
Required components/tools:
T20 star screwdriver
●
●
Flat head screwdriver
●
●
Moving the sensor housing (RS18 & RS24 only)
Unclip the reed switch from the housing (A).
1
Unhook the interceptor board harness from sensor
2
housing so harness is loose (B).
Remove the #8x16 screws (2x) from the sensor housing (C).
3
42
@5
OPTIONAL — CHANGING OVER DOOR HINGES
A
B
C
Move the sensor housing so that the opposite reed switch
4
clip is aligned with the center of the cabinet (D).
D
Reinstall the sensor housing using #8x16 screws (2x)
5
into the pre-drilled holes in the cabinet top panel (E).
6
Clip the reed switch into the sensor housing in the
pocket closest to the centerline of the cabinet (F).
Press the harness from the interceptor board into the
7
forks on the sensor housing (G).
E
F
G
Advertisement
Table of Contents
