Table of Contents
Advertisement
!1
A
-
SECURE TO THE CABINETRY ON THE SIDES
Open the
drawer halfway.
Using a flat
bladed
screwdriver,
prise the gray
rubber plug out
of the trim
moulding.
2
Using a small
Philips screwdriver,
screw through the
trim moulding,
securing the side
mounting bracket
to the cabinetry.
Do not damage
the rubber
trimseal.
Where the toekick
meets the bottom
of the tub is the
cut-off point
1
Lay the toekick face down on
a chopping board or similiar
2
Mark this point on the
Score along the marked
toekick with a pencil
cutoff line with a knife
1
Replace the gray
rubber plug back into
the trim moulding
and ensure the trim
seal is facing forward.
Repeat for all
four brackets.
!3
A
-
FIT THE SUPPLIED TOEKICK PANEL
3
Turn the toekick over and
score along the same line
4
19
Gently snap off the excess
!2
A
-
OPTIONALLY SECURE TO THE CABINETRY ABOVE
3
5
19
Smooth the edge with a file.
Be careful of sharp edges.
6
Snap off the two end tabs
7
8
Slide the toekick onto
the mounting rails
either side and screw
the toekick onto the
bottom of tub on
either side.
IMPORTANT!
Do not overtighten screw.
The top mounting
brackets will only
bend upwards a
(x2)
maximum of 3/8"
(10 mm).
Mounting rail
9
10
Advertisement
Table of Contents
