Adjustment Of Machine; Adjustment Of Column Clamp; Interval Adjustment Between Arm And Column Sleeve ＆Adjustment Of Clamp; Adjustment Of Spindle Box Clamp - Nambuk NRD-1000 Product Manual

Operating Manual
NRD-1000

7. Adjustment of Machine

7-1. Adjustment of Column Clamp

If the column has a low clamping force(if the
column is clamped and the are rotates), loosen
the clamp nut, tighten
properly and tighten the clamp nut again.
If the nut is tightened too much, the column
sleeve will not rotate smoothly even if the
column clamp is loosened.
7-2. Interval Adjustment between Arm and
Column Sleeve ＆ Adjustment of Clamp
Arm and Column sleeve of adjustment gap, adjust
it by adjustment of gap. Arm and column sleeve
of clamp, adjust it by clamp adjustment nut.
Please don't tighten
Clamp adjust nut
Interval adjust nut
24 Nambuk Co.,Ltd

7-3 Adjustment of Spindle Box Clamp

After using for a longtime, when clamp lever
lock, If right and left move of spindle box,
nut is about 1/2 ~ 1 circle to lock upward,
certification! clamp condition at a time.
the adjusting nut
If adjust is completion, nut is tightening
again
Column clamp lever
Adjust nut
Adjust nut
Clamp nut
7-4
leveling adjustment of spindle box and Arm
and Before＆Behind Horizontal leveling
Clamp condition of spindle box is release and
after
horizontal leveling bolt (2EA), as left and
right moving of spindle box is smoothness,
standardize release to left and right adjust
bolt.
Slide surface interval
complete tightening
Left-Right horizontal adjust bolt
2EA
clamp nut
Clamp nut
Adjust bolt
＆ Horizontal
left and right