Table of Contents
Advertisement
6. Operation of the machine
6-1.
Power Source Input of the Machine
Life Braker switch at front lower part of
column and then press "ON"switch of operation
plate located at the left side to spindle box,
which allows power source to be connected with
"pilot lamp" lighted up.
no fuse braker
MONOLEVER SWITCH
SPINDLE
CHANGE LEVER
SPINDLE FEED LEVER
SPINDLE BOX
LEFT-RIGHT FEED HANDLE
Operating Manual
6-2. Rotation Direction of Spindle
After fixing rotation times into the lowest,
push monolever switch backward, and motor for
Spindle will be driven. If pulling Forward, the
rotation direction of Spindle will be opposite,
compared with the case of pushing backward.
6-3. Feed of Spindle
In condition that Spindle is rotated forward,
and make Spindle feed lever be pulled to the
front of operator, which will allows spindle to
be manual feed.
6-4. Ascending and Descending of Arm
After release of Arm clamp and if pushing
monolever switch upward(↑), arm is elevated.
and if pushing monolever switch downward(↓),
arm will be descended. Before elevated and
descended
of
arm,
necessarily.
When
work-processing,
unclamp condition necessarily.
NRD-1000
release
of
Arm
clamp
you
work
Nambuk Co.,Ltd
21
Advertisement
Table of Contents
