Additional Resources - madVR Labs Envy Barco Setup Manual

D. While on the Envy Incoming Signal menu, press the right arrow once to access the Outgoing
Signal Information. Make sure that the "Framerate" shown here matches the "Framerate" from
the Incoming Signal Information menu (in this example, both should show 23.976).
E. On the Outgoing Signal Information menu, make sure the Outgoing Transfer function shows
"SDR". This should always be the case with the Envy, even for HDR. This is because the Envy
does the HDR processing and then outputs its signal as SDR (but still delivering an HDR image).
Otherwise, if the Envy outputs the signal with the HDR flag, then the Barco projector will apply
its own tone mapping on top of the Envy's tone mapping, which will look bad due to double
tone mapping. If this Outgoing "Transfer function" does show "HDR", make sure the Envy HDR
Flag is set to Off (see step 3).
F. If the colors look undersaturated: If you are not using a 3D LUT, and using a projector that
supports DCI-P3, make sure that the "Colorimetry" shown in the Outgoing Signal Information
menu shows "DCI-P3". If it shows "BT.2020", please revisit step 3b and step 4. If you are using a
projector that does not support DCI-P3, then the Colorimetry should instead show "BT.709".

Additional Resources

This concludes the Barco setup instructions. We recommend also review the Envy Introduction to
Profiles guide, and the setups guides for source devices such as Kaleidescape and Apple TV. This and
other such resources are available at www.madvrenvy.com/#downloads. Thank you and enjoy your
Envy!
8
madVR Envy – Barco Setup Guide
Copyright © madVR Labs, LLC. All rights reserved.