madVR Labs Envy Barco Setup Manual page 4

3. Next, we need to set some important values in the Envy Display Calibration menu. To access this
menu, press the top-right button on the Envy remote, then press the right arrow once, then
select "Base Settings" from the bottom of the menu.
a. If you will not use a 3D LUT, you must set the Envy Transfer Function value to 2.4, to
match the Gamma value in the Barco, as configured step #2. If you used a different
Gamma setting in the prior step, set that value in the Transfer Function here, rather
than 2.4.
b. If your Barco projector does not support the DCI-P3 color space, set the Gamut in the
Envy menu to "BT709" and skip now to step 7. Otherwise, if your projector does support
DCI-P3, and you will not use a 3D LUT, set the Gamut to "DCI-P3". In conjunction with
4
madVR Envy – Barco Setup Guide
Copyright © madVR Labs, LLC. All rights reserved.