madVR Labs Envy Sony Setup Manual page 3

2. Assuming you changed the Color Space from RGB to YCbCr in step 1B above, go to the Envy
HDMI Configuration menu (press the Envy menu button, then press the right arrow button four
times) and set the Slow YCbCr Handshake option to On. This optimizes the HDMI handshake
with the Sony. Without this setting, you may experience green flashes during HDMI handshakes.
If you later use a 3D LUT calibration and set the Color Space back to RGB, set this handshake
setting back to Off.
3. If not using a 3D LUT, it is critical that the Envy Transfer Function value match the Gamma
Correction setting in the Sony menu. We recommend using a value of 2.4 for both the Sony and
Envy. To access the Gamma Correction setting in the Sony - from the main "Picture" menu,
select Expert Setting. Then set the Gamma Correction value to 2.4.
To access the Transfer Function setting In the Envy: From the Display Calibration menu (press
the top-right button on the Envy remote, then press the right arrow button once), change the
Transfer Function to 2.4. In the event you wish to use a different Gamma Correction in the Sony,
such as 2.2, please make sure you then also set the Transfer Function to match (2.2 in that case).
3
madVR Envy – Sony Setup Guide
Copyright © madVR Labs, LLC. All rights reserved.