Non-Glare Glass; Plexiglass And Acrylic Care - Hussmann Q3-DC Installation And Operation Manual

shortening product shelf life.
Soap and hot water are not enough to kill this bacteria.
A sanitizing solution must be included with each
cleaning process to eliminate this bacteria.
1. Scrub thoroughly, cleaning all surfaces, with
soap and hot water.
2. Rinse with hot water, but do not fl ood.
3. Apply the sanitizing solution according to
Hussmann's directions.
4. Rinse thoroughly.
5. Dry completely before resuming operation.
CLEANING GLASS and MIRRORS
Only use a soft cloth and mild glass cleaner for
cleaning any glass or mirrored components. Be
sure to rinse and/or dry completely.
Never use hot water on cold glass surfaces!
It may shatter and cause serious injury! Allow
glass surfaces to warm fi rst.
CLEANING PRECA UTIONS
WHEN CLEANING:
Do Not Use high pressure hoses
Do Not Introduce water faster than waste
outlet can drain
Never Use a Cleaning or Sanitizing Solution
that has an OIL BASE (these will dissolve
the sealants) or AMMONIA BASE
(this will corrode the copper components
of the case)
TO PRESERVE FINISH
Do Use wa ter and a mild deter gent for
the exterior only!
Do Not Use abrasives or steel wool pads
as these will mar the finish.
User Information

NON-GLARE GLASS

The high optical clarity of this glass is possible due
to special coatings on the glass surface itself. To
preserve this coating and the optical clarity, keep the
glass clean.
Water is the only solution recommended for use in
cleaning non-glare glass. The damage to the glass
from improper, caustic solutions is irreparable.
In addition to cleaning the glass with the recommended
product, there are precautions that should be taken
when working and cleaning the inside of the case.
• When cleaning the inside of the cases, we
recommend that the glass be fully opened and
covered to prevent solutions from splashing
onto the glass and ruining the coating on the
inside.

PLEXIGLASS and ACRYLIC CARE

Improper cleaning not only accelerates the cleaning
cycle but also degrades the quality of this surface.
Normal daily buffi ng motions can generated static
cling attracting dust to the surface. Incorrect cleaning
agents or cleaning cloths can cause micro scratching
of the surface, causing the plastic to haze over
time.
CLEANING
Hussmann recommends using a clean damp chamois,
or a paper towel marked as "dust and abrasive free"
®
with 210
calling Sumner Labs at 1-800-542-8656. Hard, rough
cloths or paper towels will scratch the acrylic and
should not be used.
ANTISTATIC COATINGS
®
The 210 has proven to be very effective in not only
cleaning and polishing the Plexiglass surface, but
also providing antistatic and anti-fog capabilities. This
product also seals pores and provides a protective
coating.
9
Q3-DC 0907
Plastic Cleaner and Polish available by