HUSSMANN CHINO PRODUCT CONTROL The serial number and shipping date of all equipment has been recorded in Hussmann’s files for warranty and replacement part purposes. All correspondence pertaining to warranty or parts ordering must include...
When joining, use a carpenters level and adjust legs accordingly. The legs on the Q1-SS are adjustable and do not require shims. Simply screw the leg up or down to adjust height.
Page 4
(apply additional silicone if necessary). Remove tape applied on line #4. 11.Remove front, back and end shipping braces. Q1-SS REFRIGERATED WEDGES AND STANDARD CASES Line up taper pins and line-up plates with holes on adjoining case. Bolting is located at the rear of the case, behind the air discharge wall, and behind the front body panel.
The P-trap must be installed to prevent air leakage and insect entrance into the fixture. NOTE: PVC-DWV solvent cement is recommended. Follow the Hussmann’s instructions. INSTALLING CONDENSATE DRAIN Poorly or improperly installed condensate drains can seriously interfere with the operation of this refrigerator, and result in costly maintenance and product losses.
It should be wired to a dedicated circuit. CASE-TO CASE CONNECTORS HUSSMANN now provides “CASE-TO-CASE” locking electrical connector fittings on the Q1-SS service cases. These connectors greatly simplify field installation thereby saving time and electrical installation costs. NOTE: The total case electrical draw must...
Actual ampere draw may be less than specified. Field wiring from the refrigeration control panel to the merchandisers is required for refrigeration thermostats. Most component amperes are listed in the “Case Specs” section, but always check the serial plate.
CLEANING Hussmann recommends using a clean damp chamois, or a paper towel marked as “dust and abrasive free” with 10 Plastic Cleaner and Polish available by ®...
TOWARD THE MOTOR. COILS The coils used in Hussmann merchandisers may be repaired in the field. Materials are available from local refrigeration wholesalers. Hussmann recommends using #15 Sil-Fos for repairs.
Page 16
The installer is responsible for following the instal- lation instructions and recommendations provided Appendices by Hussmann for the installation of each individual type refrigerator. Refrigeration piping should be sized according to Hussmann’s equipment recommendations and installed in accordance with normal refrigeration practices.
APPENDIX D. – Recommendations to user - Refrigerated Hussmann should provide instructions and recom- mendations for proper periodic cleaning. The user will be responsible for such cleaning, including the cleaning of low temperature equipment within the compartment and the cooling coil area(s).
Daily cleaning of the external areas surrounding the storage or display compartments with detergent and water will keep the equipment presentable and prevent grime buildup. Load levels as defined by Hussmann must be observed. The best preservation is achieved by following these rules: a) Buy quality products.
Page 20
The MODEL NAME and SERIAL NUMBER is required in order to provide you with the correct parts and information for your particular unit. They can be found on a small metal plate on the unit. Please note them below for future reference. Q1-SS 0707...