Hussmann Q1-DC Wedge Technical Data Sheet

8
These merchandisers are manufactured to meet ANSI/National Sanitation
Foundation Standard #7 requirements.
We reserve the right to change or revise specifications and
product design in connection with any feature of our
products. Such changes do not entitle the buyer to
corresponding changes, improvements, additions or
replacements for equipment previously sold or shipped.
ETL Listed
40427
ETL Sanitation
40427
Specialty Products
Q1 DC Wedge
PHYSICAL DATA
Merchandiser Drip Pipe (in.)
Merchandiser Liquid Line (in.)
Merchandiser Suction Line (in.)
Estimated Charge (lb)***
4ft
5ft
6ft
*Dependent on case length and refrigerant type.
*** This is an average for all refrigerants types.
Actual refrigerant charge may vary by approximately
half a pound.
GLYCOL REQUIREMENTS
GPM PSI
NA NA
NA NA
NA NA
1 of 8
Note: This data is based on store temperature and
humidity that does not exceed 75F and 55% R.H.
Discharge Air (F)
Evaporator (F)
Note: Not recommended to control temp by regulating
coil temp allow t-stat to cycle and control temp.
Btu/hr/Total*
Parallel
Conventional
Btu/hr/Total*
Parallel
Conventional
Btu/hr/Total*
Parallel
Conventional
Btu/hr/Total*
Parallel
Conventional
Btu/hr/Total*
Parallel
1 ½*
Conventional
3/8*
*For all refrigeration equipment other than Hussmann,
use conventional Btu values.
5/8*
1.2
Frequency Hrs
1.5
1.8
OFFTIME
Temp Term °F
Failsafe Minutes
ELECTRIC or GAS
Q1 DC Wedge
Technical Data Sheet
REFRIGERATION DATA
26
20
45° IS
1200
1380
45° OS
1000
1150
22.5° IS
1200
1380
22.5° OS
1000
1150
90° OS
2000
2300
DEFROST DATA
Not Recommended
Rev A
6
54
40