Table of Contents
Advertisement
26230, 80107 NAMUR
Circuit diagrams
Œ
NAMUR hole pattern
Conversion instructions of 5/2 into 3/2 way function
5/2 way function (original mode of supply)
5/2
7
6
3/2 resp. 5/2 way function can be achieved just
by swapping enclosed adaptor plates. Make sure
Marker and Arrow do match as shown on above
drawing. Original mode of supply: 5/2 function.
Warning
These products are intended for use in industrial compressed air sys-
tems only. Do not use these products where pressures and tempera-
tures can exceed those listed under 'Technical Data'.
Before using these products with fluids other than those specified, for
non-industrial applications, life-support systems, or other applications
not within published specifications, consult NORGREN.
Through misuse, age, or malfunction, components used in fluid power
systems can fail in various modes. The system designer is warned to
consider the failure modes of all component parts used in fluid power
N/UK 5.4.302.06
“
32
2
3
2
3
5
Our policy is one of continued research and development. We therefore reserve
the right to amend, without notice, the specifications given in this document.
M5
4
3/2 way function
3/2
7
6
6
arrow
7
Marker
systems and to provide adequate safeguards to prevent personal
injury or damage to equipment in the event of such failure.
System designers must provide a warning to end users in the
system instructional manual if protection against a failure mode
cannot be adequately provided.
System designers and end users are cautioned to review specific
warnings found in instruction sheets packed and shipped with these
products where applicable.
2
Port 2 (A)
Coding stud threaded
3
M5 (10 deep)
4
Port 3 (R)
5
9/05
Advertisement
Table of Contents
