Wear Check For The Slip-On Coupling - Vetter ManuTel SlimLine Operating Instructions Manual

Maintenance

Wear check for the slip-on coupling

6.3 Wear check for the slip-on coupling
Personnel:
Protective equipment:
Fig. 16: Wear check
Check the thickness of the slip-on coupling for wear on a regular basis:
If the sheet thickness of the slip-on coupling is less than 3 mm at any point, the slip-
n
on coupling needs to be replaced.
32
WARNING!
Danger of accident due to wear!
The material thickness must be at least 3 mm at each point of the slip-on
coupling. (Fig. 16). The slip-on coupling needs to be replaced if the mate-
rial thickness is less than 3 mm due to wear. If it is not replaced, material
failure is to be expected when loaded. There is a danger of accident if the
load falls.
– Test the wear limit of the slip-on couplings on a regular basis.
– Replace the slip-on couplings immediately if they fall below the wear
limit!
n Driver of industrial trucks
n Protective work clothing
n Industrial helmet
n Protective gloves
n Safety shoes
®
ManuTel telescopic fork arm Type SlimLine V1.09/2019