Blind Spot Detection (Bsd) - Hongqi HS5 Manual

4-5. Use other driving system

Blind Spot Detection (BSD) *

The system contains a blind spot detection, side warning assist (SWA) and a cross traffic alert (CTA) to
provide driving assistance.
Blind spot detection and side warning assist
Cross Traffic Alert (CTA)
Blind Spot Detection (BSD) ON/OFF
190
When the gear lever is in D position and the vehicle
speed is greater than 30km/h, if the rear-side vehicle in
the 7m (m) blind area or the 7 - 70m (m) interval behind
the vehicle, the corresponding rear-view mirror warning
indicator turns on. If the switch of the turn signal on the
corresponding side is turned on at this time, the warning
indicator will flash and a warning sound will be sent out
at the corresponding side to remind the driver that it is
dangerous to change lanes at this time.
When the gear position is in R gear and the vehicle
speed is 0~10km/h, if there is a crosswalk vehicle
behind the vehicle, the indicator light in the
corresponding side rearview mirror will be lit, the
instrument cluster will display the warning icon, and the
corresponding side speaker will give out a warning
sound to remind the driver to pay attention to the
crosswalk vehicle.
When BSD off key is pressed, the cluster gauge will
display the system off indicator lamp and BSD system is
turned off. Press the blind area detection button again,
the indicator turns off, and the blind area detection
system turns on.
If the system is faulty, the blind spot detection system
will be in OFF status and cannot be turned on with the
switch.