Hussmann IMPACT ED1 Installation Instructions Manual page 6

P/N 0406929
Fastening Wedges
All wedge cases, when fastened
to a parent case, use a hinge
assembly in place of a joining
plate.
Complete steps 6, 7 and 8 with
the following steps replacing
step 7.
90° Inside and Outside Wedges
Align top extrusion and insert
7
hinge assembly similar to the
joining plate.
A. Six holes in the hinge
assembly will locate the
assembly by lining up with six
pilot holes drilled in the wedge
top extrusion.
The two remaining holes in the
hinge assembly will be on the
parent case side of the joint and
require drilling 0.140 diameter
pilot holes for the screws. (
or No. 28 drill bit)
Use #8 screws to fasten the
hinge assembly.
6
Drill 0.140 Dia. Pilot
Holes (2 Places)
9 /
64
Top Extrusion
Parent Case
Six Pre-Drilled Holes
For Locating Hinge
Assembly
Figure 10. Fastening 90° Wedges
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
®
Merchandisers
Hinge
Assembly
Wedge