Pressure Setting (Eyelet Pressure); Replacing The Lower Stamp - HANG 102-00 Operating Instruction

Operating manual
12

Pressure setting (eyelet pressure)

Figure E
To increase the pressure: Turn the threaded pin clockwise.
To decrease the pressure:  Turn the threaded pin anticlockwise.
13

Replacing the lower stamp

Press the eyelet channel to the side to allow easier handling.
Figure F
BA_09/2018en
If you wish the eyelets to be pressed harder or if the
eyelets are being pressed too hard, you must regulate
the pressure by moving the lower stamp [11].
Figure E.
 Release the threaded pin [12].
 Use the threaded pin [13] to move the lower stamp
[11].
 Use the threaded pin [12] to clamp the lower stamp
[11] tight again.
 Loosen the clamping screw [15] on the stripping spring [14]
and swivel it aside. Figure F.
 Release the clamping screw [17] on the lower stamp [16].
 Pull out the lower stamp [16] upwards.
 Install the new lower stamp in the opposite sequence.
4
Eyeleter 102-00