Replacing The Upper Stamp; Malfunctions In The Eyelet Feed - HANG 102-00 Operating Instruction

Operating manual
14

Replacing the upper stamp

Press the eyelet channel to the side to allow easier handling.
Figure G
15

Malfunctions in the eyelet feed

The eyelet feed is set up for a single eyelet size. If eyelets of a different size,
defective eyelets, dirt or other foreign objects get into the eyelet container or the
feed, malfunctions will occur.
 Remove the tension spring that holds the eyelet channel to the body.
 Remove the eyelet container (see "Replacing the bristle disk"). (Figures H–K)
First empty the eyelet container, or the eyelets will scatter everywhere.
 Repair the cause of the malfunction.
 Reinstall the eyelet container.
BA_09/2018en
 Screw out the upper stamp [18] using the (size 12)
open-ended spanner provided.
If the catch pin [19] also has to be replaced, user
pliers to pull it down and out. Figure G.
 Insert the new catch pin through the new upper
stamp and turn both of them together into the tappet.
 Do an eyeleting test and, if necessary, readjust the
pressure. (See "Adjusting the pressure").
5
Eyeleter 102-00