Installation Instructions; Preparing For The Installation - Fisher & Paykel DCS CDV2365N Installation Instructions Manual

INSTALLATION INSTRUCTIONS

PREPARING FOR THE INSTALLATION:

Be sure to read the section on the proper ventilation requirements before you begin.
Step 1: Unpack the unit, the regulator, and remove all packing between all the burners, rings, and caps. Re-
move the grates from their boxes.
Step 2: With the necessary tools and hardware ready, measure the distance from the back and sides of the
countertop and cabinet to locate the position of the cooktop Cutout.
Step 3: Make your Cutout according to the dimensions in section 'Cutout and Cabinetry Dimensions'. Square
the cutout to the countertop.
Step 4: Lower the cooktop into the countertop cutout, being careful not to damage the counter, inlet pipe
threads, or the power cord of the cooktop.
Step 5: Square the cooktop to the cutout and install the (4) retaining brackets onto the 8 holes for CDV2-365
and (2) retaining brackets onto 4 holes for CDV2-304 located at the bottom of the unit (See Figure 1
below). If the retaining brackets are not installed, the cooktop will not pull down to countertop.
Step 6: Tighten the 4 preloaded thumb screws which will keep the unit secured. Do Not Over-tighten (See
Figure 2 detail below).
NOTE:
Some installations may not have adequate clearance at the front for the 'Z'-shaped retaining bracket. In those cases, use
the 'L'-bracket provided. Fasten the bracket to the bottom of the cooktop chassis using one of the screw holes provided
for the retaining brackets. Make sure the bracket extends out far enough to contact the inside of the cabinet face. While
pushing down on the front edge of the cooktop from above,attach the bracket to the cabinet. This step wil insure that the
edge of the cooktop is flush with the counter surface. Plug the adjacent unused hole in the cooktop chassis with a screw.
See Figure 3.
Step 7: Install the regulator with the arrow in the direction of the gas flow (towards the cooktop) using a
sealant on the male pipe threads. Put burner rings and burner caps in place.
Step 8: Connect the gas line to the unit. Refer to section 'Gas hook-up'.
Step 9: Open the manual valve to let the gas flow. Check for gas leak.
Important!
Leak-testing of the appliance shall be conducted according to the manufacturer's
instructions. See section 'Leak testing' for instructions.
Step 10: Plug the unit into a wall outlet.
Step 11: Turn the front burner knob on first and apply a match to the burner until the gas lights, being cau-
tious not to burn your hand or other parts of your body. When the gas is first activated, there is air
present in the gas lines. The match applied to the burner makes it easier and safer to clear the air/gas
mixture. Use Caution to avoid burn injury.
Step 12: Put grates in place.
BRACKET (P/N 216594)
SCREW (P/N 211464)
FIG.1
FIG.2
SCREW (P/N 211241)
7
US
CA