Required components/tools:
1x Cross-head screwdriver
●
●
M4 Hex key
●
●
1/2" (13mm) Spanner
●
●
Adjust the door panel
Note: All door panels have full axis adjustment to ensure they are flush with adjacent walls.
To adjust the height of the door panel relative to the door, use M4 hex key to turn the top
1
M8 screw (A) clockwise to lower or counter-clockwise to raise the door panel until the gap
with the cabinetry above is 1/8" (3mm).
To adjust the depth of the door panel, loosen the side screws (B) from each side and slide
2
the panel forward/backward. Re-tighten once satisfied.
3
To adjust the door panels further, remove the door panels then loosen the fixing screws for
the hanging bracket and move the bracket sideways to suit. (C)
Once satisfied with the door panel position, fully tighten M8 washer and nut to the stud
4
using a M4 hex key (A).
A
B
34
@0
C
INSTALL DOOR PANELS
Fix the locking brackets
Loosen the screw at the bottom of the door, and slide the locking bracket out until it
1
touches the panel (D).
Fix the locking bracket to the door panel with 8Gx16 countersunk screw (E).
2
Re-tighten the screw at the bottom of door (F).
3
D
E
F