Table of Contents
Advertisement
IMPORTANT!
Ensure to protect the finish of the Fisher & Paykel Stainless Steel door panels. Leave
●
●
the protective film on the panels when hanging and remove the film only when the
installation is complete.
Attach the top and side hanging brackets to (Stainless steel) door panel
1
Remove the M8 washer and M8 nut from the M8 screws at the top the door (A).
Remove the top hanging bracket from the
2
top of the door and set aside (B).
3
Unscrew the adjustment screws by 1/8"
(3mm) to move close to the middle of
adjustment range (C).
!8
INSTALL BRACKETS TO DOOR PANEL (STAINLESS STEEL)
A
C
Required components/tools:
Door panel attachment kit
●
●
– 6x Side panel brackets
– 6x Bracket slider
– 6x Side spacer bracket
– 30x 8Gx16 Mush washer screws (for
SS door panels only)
Align the screw holes of the bracket with the screw holes of the door panel, and fix the
4
hanging bracket to the door panel with 8Gx16 mush washer screws (D).
– 6x screws for 18" (457mm)
– 10x screws for 24" (610mm) and 30" (762mm)
1/8"
(3mm)
B
Align the side panel bracket assembly (bracket, slider and spacer) to the screw holes on the
5
side of the door panel and fix with 8Gx16 mush washer screws (E).
Drill with 3/32" (2.55mm) bit
●
●
Cross-head driver on battery drill
●
●
M4 hex key
●
●
1/2" (13mm) Spanner
●
●
D
E
E
31
Advertisement
Table of Contents
