Table of Contents
Advertisement
IMPORTANT!
Ensure the door is in line with the cabinetry front and the appliance is centered.
●
●
All four corners of the appliance must be supported firmly onto the floor to eliminate any
●
●
movement. Installing the appliance on a soft, uneven, or not level floor may cause twisting
and poor door sealing.
Adjusting height of the second appliance inside the cabinetry
1
Turn the front and rear adjustment screws using a Cross-head screwdriver (or powered
driver) to extend the feet until it engages the floor.
– One turn of height adjusting nuts is equivalent to 1/32" (0.5mm) of height adjustment.
Clockwise turn raises the height and counter-clockwise turn lowers height (A).
Front foot
adjustment
28
!6
DUAL INSTALLATION
A
Rear foot
adjustment
Required components/tools:
Cross-head screwdriver or power driver (PH2 bit) at minimum torque setting
●
●
Front foot
Continue turning the adjusting screws alternately between front and rear feet until you
2
achieve the correct alignment of the second appliance with the first appliance.
Once you are satisfied with the alignment, raise the height of the appliance by alternately
3
adjusting the front and rear feet until the top surface contacts the alcove ceiling.
– Check the alignment gauges while adjusting the screws to make sure you maintain the
alignment of both appliances.
Ensure all feet are positively engaged with the floor.
4
Rear foot
Advertisement
Table of Contents
