VERSHOLD 200406-CWS Manual page 43

automatically exit the settings.
7.8 Switching the channels in the transmitter
Open the transmitter battery compartment and press the channel
switch CH above the battery compartment to set one of the three
channels: CH1, CH2, CH3.
Set the same channel number on the transmitter and the receiver
so that the weather station (the receiver) shows the correct data.
7.9 Temperature unit (°C/°F) on the transmitter
Open the battery compartment and press the °C/°F button to
change the temperature unit on the transmitter display.
7.10 Transmitter installation
1 . Hammer a nail or install a wall plug with a hook (not included)
in the place where you want to hang the transmitter.
2 . Hang the transmitter on the nail or the wall plug with the
hook.
7.11 Receiver installation
You may position the receiver vertically using the foldable support
foot on the back, or hang it using two nails or wall plugs with
hooks (not included), performing the same steps as for transmitter
installation.
7.12 Troubleshooting
Problem: the transmitter and receiver lose their connection
43