VERSHOLD 200406-CWS Manual page 41

seconds when battery-powered.
• MODE – setting button – a short press displays the time of the
set alarm; pressing and holding for 2 seconds enables setting the
time and date. Another short press confirms the selection.
• C/F – changes the temperature units from Celsius to Fahrenheit
degrees and back again.
• UP – a short press increases the values, and changes the
temperature units from Celsius to Fahrenheit degrees and back
again. Press and hold to speed up the value increase rate.
• DOWN – a short press decreases the values. Press and hold to
speed up the value decrease rate .
• MEM – the first press displays the registered maximum value of
the indoor and outdoor temperature and humidity, the second
press displays the minimum value, the third press returns to the
initial mode (current measurement). To delete the stored values,
press and hold MEM for approx. 2 seconds when the maximum
or minimum values are displayed.
• CH – switches the transmitter channels. Each press changes the
channel to CH1, CH2, CH3, and cyclical display at the end (the
channels are displayed consecutively). Press and hold CH to
delete all data from the current channel.
7.6 Setting the date and time
1 . Press and hold the MODE button for two seconds to start
setting. The "24h" (default display mode) will start blinking on
the display .
2 . Select the desired 12h or 24h display mode by pressing UP or
DOWN. Press MODE to confirm the selection. The hour digits
will start blinking.
3 . Set the hour using the UP or DOWN button, press MODE to
confirm. The minute digits will start blinking.
4 . Set the minutes using the UP or DOWN button, press MODE to
41