Replacing Return Thermopane; Glass Assembly - Hussmann FG Installation And Service Manual

S
6-8
ERVICE

REPLACING RETURN THERMOPANE

GLASS ASSEMBLY

Requires TWO (2) people.
Always use gloves when handling glass.
1. Turn off power to merchandiser.
2. Remove hand rail.
3. Disconnect glass pane heater lead wires from
the wiring junctions.
4. With one person standing at each end of the
glass, lift the thermopane glass assembly
straight up to remove it from its retainer
channel and end posts.
5. To install glass, have one person hold each
end of the thermopane glass assembly and
carefully lower it into the retainer channel
and end-posts.
Note: It may be necessary to use a wide thin tool
(such as a putty knife) to keep trim from
obstructing glass positioning. Refer to illustration
on page 6-6.
6. Reconnect glass pane heater lead wires.
7. Replace hand rail.
8. Turn on power. Verify the heater is working
properly.
P/N 0467434_D
WARNING
!
Always disconnect the electrical power at the
main disconnect when servicing or replacing
any electrical component. This includes, but is
not limited to, such items as fans, heaters,
thermostats and lights.
Outside
of Case
Glass Assembly
Hand Rail
Glass
Assembly
End Post
Case Wall
or End
. .
WWW HUSSMANN COM