Hussmann FG Installation And Service Manual page 17

P/N 0467434_D
4. Starting at the left end of the line up, install
the bumper starter section first. To install,
a. Position internal joint trims so that the
first is flush to the left-end panel and the sec-
ond is centered between the starter bumper
and the full length bumper as shown.
b. Install full length bumpers and internal
trims offset across joints. Make sure that no
gaps exist between sections. Continue
installing the bumpers the length of the line
up.
5. Once all except the last section of bumper
have been installed refrigerate the case line up for
at least six (6) hours. The last section of bumper
should be kept inside a cooler or refrigerated
case during this time. This will allow the
bumper to contract.
6. Go to the right end of the line up and tap the
bumper to close any gaps.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Starter
Bumper
Retainer
Internal Joint Trims
7. Measure and cut last
section of bumper. Use a
miter box and fine-tooth
saw to cut last bumper to
length. Install the last
section.
8. Remove protective
film from bumper once
installation is complete.
Merchandiser
Joint
Full Length
Bumper
Bumper
Miter Box
Excel
Low Temperature
1-13