Cleaning Airflow Louvers; Cleaning Wire Racks, Pans, And Interior Panels - Hussmann FG Installation And Service Manual

M
5-2
AINTENANCE

CLEANING AIRFLOW LOUVERS

Louvers should be cleaned at least every six
months. Dirty louvers adversely affect model
performance.
1. Remove screws and louver retainer.
2. Lift the louver, then rotate the bottom out.
3. Clean the louvers with a soap and water. Dry
thoroughly.
4. When completely dry, re-install louvers and
retainer.
Louver
Louver
P/N 0467434_D
2. Lift Up
3. Pull Out
1. Remove Screws
and Louver
Retainer
CLEANING WIRE RACKS,
PANS, AND INTERIOR PANELS
With the louver assembly removed, all interior
wire racks, supports and drip pans may be lifted
out without tools. Refer to illustration on next
page.
Begin by lifting out the display racks and front
and back display rack supports. Remove display
pans, beginning from the left. Pans overlap when
properly installed.
Carefully lift up glass package guard to clear
clips attached to front panel. It is not necessary
to remove clips from panel. Lift out return air
grilles. The glass may be cleaned with most
domestic detergents, ammonia based cleaners and
sanitizing solutions with no harm to the surface.
N
EVER USE ABRASIVE CLEANSERS OR SCOURING
.
PADS
Front and rear internal panels rest on interior
panel supports. Panels and supports lift out.
Reinstall in reverse order.
. .
WWW HUSSMANN COM