Hussmann FG Installation And Service Manual page 30

D P
3-6
RIP
Installing Splashguard on End and End Case
An end splashguard and close-off panel ship with
each end assembly. End case splashguards and
close-off panels ship with the case. Install end
splashguards after main splashguards.
1. Check to be sure that all splashguard brackets
are level with the floor.
2. Position top of splashguard with the top
angled in, behind the lower panel bracket.
3. Raise the splashguard enough to align the
tabs on the splashguard brackets with the slots in
the bottom edge of the splashguard. Engage the
tabs in the slots and drop the splashguard into
place.
4. Fasten the close-off panel to the splashguard.
Cove trim may be added in the same way as for
the main splashguards.
End Case
Splashguards Installed
End Case
Front Splashguard
Close-off Panel
P/N 0467434_D
S
IPING AND PLASHGUARDS
End Case
Front Splashguard
End Splashguard Bracket
End Splashguard Installed
End Case
Side Splashguard
Close-off Panel
Upper Front
Splashguard
Retainer
Screw (4)
Front
Splashguard
Retainer
Lower
End Splashguard
Panel
End Splashguard
End Case
Side Splashguard
. .
WWW HUSSMANN COM