Setting The Rotation And Back-Up Function; Maintenance; Replacing The Batteries; Cleaning - Bosch Climate 5000 L Operating Instructions For Users

3.9.9

Setting the Rotation and Back-up function

The Rotation function can only be activated if two indoor units are
connected to one wired room controller (Twin installation). The Rotation
function switches indoor units on or off alternately.
▶ Press the FUNC. key repeatedly until the
▶ Press the  key to switch on the Rotation function.
▶ Press the . or / key to set the period that must elapse
(0 - 99 hours) before the indoor units rotate.
Default setting: the indoor units rotate every 10 hours.
▶ Confirm with  key.
▶ Press the . or / key to set the maximum temperature:
– 26... 32 °C: once the set temperature has been reached, both
appliances are switched on in cooling mode. The Rotation
function is interrupted until 24 °C has been reached.
– --: no maximum temperature to interrupt the Rotation function.
▶ Confirm with  key.
▶ Press the . or / key to adjust the lowest temperature.
– 5... 15 °C: once the set temperature has been reached, both
appliances are switched on in heating mode. The Rotation
function is interrupted until 24 °C has been reached.
– --: no lowest temperature to interrupt the Rotation function.
▶ Confirm with  key.
▶ Define which indoor unit switches on first (A or B).
▶ Confirm with  key.
While the Rotation function is active, the indoor units operate
alternately, starting with indoor unit A or B.
To change the indoor unit early:
▶ Press the K key.
If an indoor unit drops out, the respective A/B symbol flashes in the
display. The other indoor unit automatically takes over the operation.
Climate 5000 L • Climate 5000i U/L – 6721841496 (2021/10)
4
Danger due to electric shock or moving parts
▶ Disconnect the power supply before carrying out any maintenance
symbol appears.
▶ Have any maintenance steps that are not listed here carried out by an
4.1
You require 2 size AAA batteries. Using rechargeable batteries is not
recommended.
▶ Remove the battery cover ( Fig. 7).
▶ Insert new batteries, ensuring correct polarity.
▶ Reinstall the cover.
4.2
Damage to device due to incorrect cleaning!
▶ Do not directly splash or pour water onto them.
▶ Do not use hot water, thinner, abrasive powders or strong solvents.
▶ Clean indoor unit and control unit by wiping them with a soft cloth.
▶ Only have the outdoor unit cleaned by a qualified person.
4.3
The air filter may deform in direct sunlight.
▶ Do not expose the air filter to direct sunlight.
Check the air filter every 2 weeks and clean if necessary. Always clean
before and after decommissioning for longer periods.
▶ Switch off the indoor unit.
▶ Pull out the air filter ( Fig. 8).
▶ Wash the air filter with hot water and a mild cleaning agent and dry in
4.4
4.4.1
▶ Clean the air filter of the indoor unit.
▶ Leave the fan of the indoor unit running for approx. 24 h in Fan Mode
▶ Switch off the indoor unit and disconnect it from the power supply.
▶ Protect the devices from dust.
▶ Check the outdoor unit at regular intervals. Contact customer service
4.4.2
▶ Wipe the air inlet grille with a clean dry cloth so the indoor unit does
▶ Make sure that the air inlet and air outlet are unobstructed and have
▶ Check all cables and connect the power supply.
▶ If required, make sure that the air filter is installed.

Maintenance

CAUTION
work.
approved contractor.

Replacing the batteries

Cleaning

NOTICE

Cleaning the air filter

NOTICE
the shade.
When re-commissioning after decommissioning for
an extended period
Maintenance before decommissioning for an extended
period:
to allow the inside of the appliance to dry.
or an authorised service engineer if a fault occurs.

Maintenance after a long period of non -use

not blow out dust.
not been inadvertently adjusted.
Maintenance
43