Rowenta ECLIPSE QU506 Series Manual page 6

INSTALLATION
1 Remove the air inlet grid.
Buckle
3 Remove the protective film
of the particle filter.
5 Install the pre-filter.
Align the slot position at the bottom, and
buckle up the upper U-shaped buckle.
10
2 Take out the pre-filter.
Press the raised part on both sides
to pull it outwards, and take out the
pre-filter.
4 Install the particle filter.
6 Install the air inlet grid.
Align the upper two buckles and
press them tightly, then press the
two sides at lower part, slowly and
gently buckle the air inlet grid.
Buckling
position
7 Plug power supply.
INSTRUCTIONS
Control panel
Remote control
1
2
4
5
3
6
AAA Battery, 1.5 V
Battery
Screen
1 2 3 4 5
1. Fan Mode
2. Auto Night Mode
3. Speeds / Temperature / Timer /
Delayed Start
4. Auto Day Mode
5. Filter replacement indicator
6. Heater Mode
1. Oscillation
2. ON/OFF
3. Speeds / Temperature / Timer / Delayed
Start
4. Auto modes
5. Fan / Heater Mode
6. Timer/Delayed Start
Use alkaline batteries of type «AAA».
2 batteries are included with the appliance.
EN
6
11