Maintenance; Preparing The Icemaker For Long Storage - Hoshizaki KMS-1230MLH Service Manual

Modular crescent cuber serenity series
Hide thumbs Also See for KMS-1230MLH:
Table of Contents

Advertisement

10) Turn off the power supply. Remove the front panel.
11) Repeat the above steps 17) through 9) in "1. Cleaning Procedure" two times to rinse
thoroughly.
1) Repeat the above steps 1) through 11) one more time.
13) Move the control switch to the "ICE" position.
14) Replace the front panel in its correct position.
15) Clean the storage bin with water.
16) Turn on the power supply and start the automatic icemaking process.
B. Maintenance
This icemaker must be maintained individually, referring to the instruction
manual and labels provided with the icemaker.
1. Stainless Steel Exterior
To prevent corrosion, wipe the exterior occasionally with a clean and soft cloth. Use a
damp cloth containing a neutral cleaner to wipe off oil or dirt build up.
. Storage Bin/Dispenser Unit and Scoop
Wash your hands before removing ice. Use the plastic scoop provided (accessory).
The storage bin is for ice use only. Do not store anything else in the bin.
Keep the scoop clean. Clean it by using a neutral cleaner and rinse thoroughly.
Clean the bin liner by using a neutral cleaner. Rinse thoroughly after cleaning.
3. Condenser
Check the condenser once a year, and clean the coil if required by using a brush or
vacuum cleaner. More frequent cleaning may be required depending on the location of
the condensing unit.
C. Preparing the Icemaker for Long Storage
When the icemaker is not used for two or three days under normal conditions, it
is sufficient to only move the control switch to the "OFF" position. When storing
the icemaker for extended time or in sub-freezing temperatures, turn the water
off and drain out all water from the water lines and remove the ice from the
dispenser or storage bin. The dispenser or storage bin should be cleaned and
dried. Drain the icemaker water hoses using air or carbon dioxide to prevent
damage at sub-freezing temperatures.
To drain all water from the icemaker, follow the steps below. See Fig. 5.
1) Remove the front panel.
IMPORTANT
CAUTION
51

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Srk-13hSrk-13h3

Table of Contents