About This Guide; Unpacking The Switch - Cisco Catalyst 2975 Getting Started Manual

1

About this Guide

This guide provides instructions on how to use Express Setup to initially configure your Catalyst switch. Also covered are switch
management options, basic rack-mounting, stacking guidelines, port and module connection procedures, and troubleshooting
help.
For additional installation and configuration information for the switch, see the Catalyst 2975 documentation on Cisco.com.
For system requirements, important notes, limitations, open and resolved bugs, and last-minute documentation updates, see the
release notes, also on Cisco.com. For translations of the warnings that appear in this publication, see the Regulatory Compliance
and Safety Information for the Catalyst 2975 Switch on the documentation CD. The product warranty information is also
included on the documentation CD.
When using the online publications, refer to the documents that match the Cisco IOS software version running on the switch.
The software version is on the Cisco IOS label on the switch rear panel.
2

Unpacking the Switch

Follow these steps:
1. Unpack and remove the switch and the accessory kit from the shipping box.
2. Return the packing material to the shipping container, and save it for future use.
3. Verify that you have received the items shown below. If any item is missing or damaged, contact your Cisco representative
or reseller for instructions.
3
6
Catalyst 2975 switch
1
Documentation
2
AC power cord
3
4 Console cable
Two 19-inch mounting brackets
5
6 Cable guide
2
1
Cata lyst 2975
G
Serie s PoE- 48
4
7
11
10
Four rubber mounting feet
7
Six number-8 Phillips flat-head screws
8
Four number-12 Phillips machine screws
9
10 One black Phillips machine screw
Connector cover for redundant power system; two number-4 pan head screws
11
2
5
8 9