About This Guide; Taking Out What You Need; Equipment That You Supply To Run Express Setup - Cisco Catalyst 3750 Getting Started Manual

1

About this Guide

This guide provides instructions on how to use Express Setup to initially configure your Catalyst
switch. Also covered are switch management options, basic rack-mounting procedures, stacking
procedures, port and module connection procedures, power connection procedures, and
troubleshooting help.
For additional installation and configuration information for Catalyst 3750 switches, see the Catalyst
3750 documentation on Cisco.com. For system requirements, important notes, limitations, open and
resolved bugs, and last-minute documentation updates, see the release notes, also on Cisco.com.
When using the online publications, refer to the documents that match the Cisco IOS software version
running on the switch. The software version is on the Cisco IOS label on the switch rear panel.
You can order printed copies of the manuals from the Cisco.com sites and from the telephone numbers
listed in the "Obtaining Documentation" section on page 24.
For translations of the warnings that appear in this publication, see the Regulatory Compliance and
Safety Information for the Catalyst 3750 Switch that accompanies this guide.
2

Taking Out What You Need

Follow these steps:
1. Unpack and remove the switch and the accessory kit from the shipping box.
2. Return the packing material to the shipping container, and save it for future use.
3. Verify that you have received the items shown on page 3. If any item is missing or damaged,
contact your Cisco representative or reseller for instructions. Some switch models might include
additional items that are not shown on page 3.
If you do not specify the length of the StackWise cable, the 0.5-meter cable is supplied.
Note

Equipment That You Supply to Run Express Setup

You need to supply this equipment to run Express Setup:
• PC
• Ethernet (Category 5) straight-through cable (as shown)
2