Cisco Catalyst 2975 Getting Started Manual page 4

Verify that the LEDs on both Ethernet ports are green.
Step 9
Wait 30 seconds.
Step 10 Launch a web browser on your PC. Enter the IP address
10.0.0.1 in the web browser, and press Enter.
Step 11 The Express Setup Basic Settings page appears. If it does not appear, see the "In Case of Difficulty" section on
page 14.
Enter this information in the Network Settings fields:
Step 12
• In the Management Interface (VLAN ID) field, the default is 1. Enter a new VLAN ID only if you want to
change the management interface through which you manage the switch and to which you assign IP
information. The VLAN ID range is 1 to 1001.
• In the IP Address field, enter the IP address of the switch. In the IP Subnet Mask field, click the drop-down
arrow, and select an IP Subnet Mask.
• In the Default Gateway field, enter the IP address for the default gateway (router).
• Enter your password in the Switch Password field. The password can be from 1 to 25 alphanumeric characters,
can start with a number, is case sensitive, allows embedded spaces, but does not allow spaces at the beginning
or end. In the Confirm Switch Password field, enter your password again.
4