Table of Contents
Advertisement
2
* "Press Mode" previously selected
3
4
DPM
Manual
Solder Paste
Dispenser
AN115
Desoldering*
Ajustable Nano
Tweezers
Lift the tool from the holder, press and hold
the pedal to activate the tool and desolder the
component.
Once the pedal is released the tool enters in
hibernation mode and cools down.
Pad Cleaning
Clean the pads with JBC´s desoldering tool
DS360
DS360.
Micro
Desoldering Iron
For this operation JBC´s desoldering station
DSS is needed.
Solder Paste Dispensing
Apply the solder paste amount needed to
solder the new chip component.
The use of JBC´s DPM solder paste dispenser
is recommended.
9
Advertisement
Table of Contents
