Table of Contents
Advertisement
(3) Replacing the illuminated switch and its LED lamp
z To prevent electric shock, accident and injury and to prevent damage to the electrical
z
circuitry of the machine, be sure to turn the power switch off before performing the
tasks described below.
Open the service door on the side of the monitor control panel assembly.
Remove the harness connector, and then turn the illuminated switch
counterclockwise to remove it.
Pull out the LED lamp from the illuminated switch.
Replace the illuminated switch or LED lamp.
Attach the illuminated switch following the above steps in reverse, making sure
that the connector orientation is correct.
SERVICES – To be conducted by a technician only –
WARNING
Harness connector
LED lamp
Advertisement
Table of Contents
