Table of Contents
Advertisement
SERVICES – To be conducted by a technician only –
(2) Replacing the joystick
z To prevent electric shock, accident and injury and to prevent damage to the electrical
z
circuitry of the machine, be sure to turn the power switch off before performing the
tasks described below.
Open the service door on the side of the monitor control panel assembly.
While holding the thread on the bottom of the joystick shaft using a screwdriver,
turn the joystick ball counterclockwise to remove the ball, collar, and upper
Dustwasher.
Collar
Remove the two flanged screws and disconnect the harness connector to remove
the joystick.
Flanged screw
Attach the joystick following the above steps in reverse.
WARNING
Joystick ball
Dustwashers
Screwdriver
Harness connector
Advertisement
Table of Contents
