IRUS I102 Assembly Instructions

Exhibition stand

Assembly instructions

for the exhibition stand I102

constisting of:

- 6x Aluminium profiles à 1250 mm incl. 8 bores

- 6x Aluminium profiles à 1250 mm incl. 8 bores and adjustable feet

- 2x Aluminium profiles à 300 mm incl. 8 bores for fascia sign frame

- 10x Aluminium cross profiles with pointed screws for the lower and upper mounting

- 5x Aluminium cross profiles for the middle mounting

- 6x Aluminium cross profiles with pointed screws for fascia sign frame

- 20x H-profiles à 1200mm to stabilize the panels.

- 6x Extension bolt for aluminium profile

- 3x Longarm spothlights 450mm incl. bulb

10x

System

exhibition

20x

Table of Contents

Need help?

Do you have a question about the I102 and is the answer not in the manual?

Page 1 Assembly instructions System ® for the exhibition stand I102 exhibition constisting of: - 6x Aluminium profiles à 1250 mm incl. 8 bores - 6x Aluminium profiles à 1250 mm incl. 8 bores and adjustable feet - 2x Aluminium profiles à 300 mm incl. 8 bores for fascia sign frame...
Page 2 System ® exhibition Important Pointed screws must be used for all profiles with screw holes. 1. Mount the bottom cross profiles 2. Then mount the cross profiles. including the pointed screws to form the corner. 4. Then mount the cross profiles 3.
Page 3 System ® exhibition 5. Push the top profiles onto the 6. Then mount the cross profiles bolts. Ensure that the holes face including the pointed screws. upward. 8. Fully assembled exhibition stand. 7. Then mount the fascia sign frame If necessary, use the adjustable feet to compensate for unevenness in the floor.